A cane spline guide is most useful after the old spline and glue have been removed. Reed spline is the locking strip that secures pressed cane webbing in a routed groove, and its fit depends on the actual cleaned channel rather than the compressed size of the old spline. Spline that is too small can […]
Tag Archives: Cane Webbing Groove
caning wedges 10 pack gives a pressed-cane installer multiple temporary holding points around the chair groove. The wedges are not used to create final drum-tight tension. Their job is to keep the wet webbing centered, seated, and stable while the installer works around the perimeter and prepares for spline. Even tension comes from sequence. If […]
A caning chisel is most useful when it removes old spline in small controlled sections instead of being treated like a pry bar. The chair groove is part of the frame, so every cut should free the old material while preserving the groove width, depth, and outer lip for the new pressed-cane installation. Clean removal […]
Choosing the correct cane spline is essential when installing pressed cane webbing in a chair seat, back, cabinet panel, or decorative furniture opening. The spline must fit the groove together with the webbing without sitting loosely or requiring enough force to damage the frame. Buyers should measure the cleaned groove, identify the webbing material, compare […]




